This area will help fast track you in planning, setting up and managing NetFlow in your environment. NetFlow is an embedded instrumentation within Cisco IOS Software to characterize network operation.

Network specialists of various levels within an organization need to be able to report on traffic traversing sites, key links and data centers without deploying probes. They use NetFlow Auditor powered by DigiToll’s unique methods of collection to capture and analyze every NetFlow record with aggregation options and small footprint real-time and long-term storage. From Telco to SME you will recognize the superior reliability and performance of the DigiToll NetFlow Auditing solutions, as well as the management benefits offered.

Configure sFlow - HP Procurve

HP Procurve Switch 5400, 3500, 2600 or 8200 series (K code)

Configuring sFlow directly on the CLI.
Enter the Config mode:
    Configure destination collector
      sflow <1-3> NetFlowAuditor-IP-address Default-sFlow-UDP-Port
        <1-3> refers to the sFlow instance
        6343 is the Default-sFlow-UDP-Port on the NetFlow Auditor Collector. This can be changed if required Configuration->Devices->UDP-Port.
        eg: sflow 1 destination 10.10.10.1 6343

    Sampling Activation
      sflow <1-3> sampling Number-of-sampled-packets
      eg: sflow 1 sampling all 100

    Polling Activation
      sflow <1-3> polling N
        N is the number of interval (in seconds) between polling intervals. Do not set greater than 60
      eg: sflow 1 polling all 60

Remember to save the Configuration

HP Procurve Switch 5400zl, 3500yl and 6200yl


HP Procurve Switch 2800 or 5300 series

    2800 Series must be running Software Revision I.08.105 and Firmware (ROM) version I.08.07
    5300 Series must be running Software Revision E.10.37 or higher

Next Steps

Whitepapers

Product information

Brochures

Presentations and Galleries

learning events


NetFlow Auditor On Demand Learning Centre

Cisco NetFlow Configuration

Other NetFlow Configuration

sFlow Configuration

IPFIX Configuration

cron